RailClamp Winch Handle Holster
Color: Matte black
Variant
productActions.specLeadTimeValue
Each piece is printed to order in our Slovenian workshop, typically within 5 to 7 working days.
Made in
Slovenia · EU
Ships in
5–7 days
Returns
30 days
A snug holster that stows your winch handle on the rail, out of the cockpit sole and always within reach. The stiffer PETG-CF body holds its shape season after season. What's included: 1× printed holster + clamp (PETG-CF), 1× TPU rail insert, A4/316 stainless hardware. Fits most standard winch handles and rails up to 32 mm.
- Material
- ASA (UV-stable)
- Hardware
- A4/316 stainless
- Variants
- 1 sizes
- Lead time
- Made to order, ships in 5 to 7 days
- Install
- 2 min, two bolts
- Made in
- Slovenia, EU
ASA (UV-stable) is a UV-stable engineering polymer that survives full marine sun and salt without yellowing or embrittling. The a4/316 stainless hardware is the same alloy used on yacht standing rigging.
Made to order: nothing sits in a warehouse. No air freight, no surplus stock, no overseas factory.
- 1× RailClamp Winch Handle Holster (ASA (UV-stable))
- 4× A4 / 316 stainless hex bolts
- 1× 4 mm hex key
- 1× printed install card with QR to /install
- Will it fit my rail?
- See the sizing guide. If you're between sizes, round up.
- Does it scratch the rail?
- No. A TPU shock insert sits between the ASA cradle and the polished stainless. We tested it for a full season: no marks.
- How soon does it ship?
- Each part is made to order, then finished and checked by hand. We batch orders and ship 5 to 7 working days from purchase.
Design features
Built for
Marine conditions
UV-stable ASA and A4 stainless. Tested through a full Adriatic season on a working yacht.
Engineered to
Clamp, not drill
TPU shock insert grips polished rails without scratching. Removes in 60 seconds.
Designed to
Last 5+ seasons
Replaceable shock insert. Lifetime replacement at material cost, see /care.
Materials & hardware
Engineered to shrug off salt.
Plastic
ASA (UV-stable): UV-stable engineering polymer that survives full marine sun and salt spray for 5+ seasons.
Hardware
A4/316 stainless hex bolts. Marine-grade corrosion resistance, the same alloy used on yacht standing rigging.
Mounting
No drilling. Clamps around the existing rail with two bolts. Removes in 60 seconds, leaves no trace.
Care
Rinse with fresh water after salt exposure. Hand-wash with mild soap if needed. Avoid solvents and abrasive cleaners. Inspect TPU insert for wear every season; replace if compressed or torn.
Install
Four bolts. 2 minutes.
01
Loosen
Back off both A4 hex bolts with the included 4 mm key.
02
Seat
Open the clamp around your existing stainless rail.
03
Align
Bring both halves together, the cradle is sized for your rail.
04
Tighten
Hand-tighten. The printed thread inserts handle 6–8 Nm comfortably.
Safety
GPSR notice: Accessory mount only. Not intended for load-bearing, life-saving, rescue, rigging, steering, engine, fuel, through-hull or other safety-critical applications. Inspect before use and discontinue use if damaged. Suitable for cameras, phones, lights, organizers and similar accessories. Full safety information at /safety.
